PUIG LICENSE PLATE HOLDER HONDA 8722N

PUIG LICENSE PLATE HOLDER HONDA 8722N

Replace your motorcycle's original license plate holder with the Puig license plate holder, which thanks to its elevated location gives a sporty look to your motorcycle.

Honda CB500F 2016 - 2024

Honda CBR500R 2016 - 2023

Fixed or adjustable in inclination

Incorporated tilt immobilization system

Brake light not included

Adjustable turn signal support

​Includes kit (license plate light + shifter + approved catadioptric)

NOT COMPATIBLE WITH SIDE CASES The license plate holder reference does not include the lighting group wiring extension. See the reference below in Accessories if available.

REF.8722 N

ORIGINAL FLASHING LIGHT SUPPORT SET

Essential if you want to keep the original flashing light on your motorcycle when mounting our license plate holder

Check the measurements of the holes once the flashing light has been removed to determine the reference to choose.

REF.1945 N

FRONT FLASHING LIGHT EXTENSION

Wiring with OEM connector

Cable length: 300mm

REF.4854 N

LIGHTING GROUP INSTALLATION EXTENSION ON LICENSE PLATE HOLDER

Wiring with OEM connector

Cable length: 300mm

REF.3853 N

REAR FLASHING LIGHT EXTENSION

Wiring with OEM connector

Cable length: 300mm

REF.4854 N

The set combines steel parts with an epoxy paint finish and polyamide parts, achieving a significant weight reduction compared to the original support.

Some license plate holders have the option of being fixed or adjustable depending on the reference that is attached to each motorcycle. They incorporate supports for turn signals, but it is important to keep in mind that they are not compatible with the original turn signals, which can be adjusted horizontally up to 3 cm.

The assembly of the piece is very simple and comes with instructions.

It is important to mention that the support does not include turn signals; these must be purchased separately. In addition, the connectors for the license plate light are not included.